EdilKamin INPELLET 54 Installation, Usage Et Maintenance page 21

THERMO TECHNICAL CHARACTERISTICS
Tank capacity
Efficiency
Max. power output
Available power
Fuel consumption (min./max.)
*
Heating capacity
Weight (including packaging)
Diameter smoke duct (male)
Diameter air intake duct (male)
*
The heatable room dimensions are calculated on the basis of pel-
lets with an lhv of at least 4300 kcal/kg and home insulation in com-
pliance with Italian law 10/91, and subsequent changes together with
an expected heat output of 33 Kcal/m³ per hour.
ELECTRICAL DIAGRAM
RS485/AUX
M
M
N
N
SOS AUX
F F
RESERVE
R
R
SENSOR
RS485 SERVICE
(optional)
LITHIUM
+
CR2032
A
D D A
SMOKE
EXPULSION MOTOR
F
F
RIGHT-HAND
TM 150 °C
VENTILATION
LEFT-HAND
VENTILATION
M COCHLEA
AUX/RS485 PORT
(connected via optional serial port cable code 640560)
This is a clean, potential free contact, useful for connecting a
telephone combiner or other control devices via an optional
cable.
FEATURES
15 kg
90,1 %
8 kW
6,5 /24 hours
0,5 / 1,9 kg/h
210 m³
157 kg
80 mm
50 mm
G G
L H
L
H
FLOW
SENSOR
RPM SMOKE
IN T° J
Room
temperature
PROBE
(optional)
R
R
P
P
AUXILIARY
B
C VENTILATION
B
C
RES IGNITION
MAINS 230
VAC
50 Hz +/-10%
E
E
ELECTRICAL CHARACTERISTICS
Power supply
Average power consumed
Power consumed upon
ignition
Remote control frequency
(as standard)
Protection on electronic
*
board
N.B.
1) bear in mind that external devices may cause interference.
2) caution: live parts. Servicing and/or inspections must be
carried out by qualified staff.
SAFETY DEVICES
• THERMO COUPLING: located on the smoke
exhaust, detects the temperature. On the basis of the
parameters set, check the ignition, working and turn-
off phases.
• AIR FLOW SENSOR: Positioned in the suction
channel, this intervenes when the fuel air flow is
incorrect, with consequent depression problems in
the smoke circuit.
• SAFETY THERMOSTAT (150 °C): Intervenes
when the temperature within the insert is too high.
Blocks pellet loading causing the insert to turn off.
• ROOM TEMP. DETECTION PROBE: located
on the remote control. Alternatively it can be connec-
ted up to the electronic board inside the insert.
BACKUP BATTERY
A backup battery is found on the control board (3-Volt
CR 2032 battery). Its malfunction is indicated with the
following messages: (not considered a defect but due
to normal wear-and-tear): "Battery check". For more
detailed information, please contact the DEALER who
has performed the first 1st ignition.
PELLET LOADING
A convenient front drawer allows you to load the pel-
lets in complete comfort, without having to remove
the hearth from its housing, and therefore in absolute
safety and in compliance with standards EN 14785.
21
230V 10% 50 Hz
ac +/-
120 W
400 W
Radio waves 2.4
GHz
Fuse 2°AT, 250 V
AC 5x20