Sensors; Sensor Placement - Smanos X330 Mode D'emploi

EN

Sensors

Sensor Placement

The alarm system is most effective with well-placed sensors. Determine which areas you
want to monitor and with what sensors. In the picture below are potential places shown
for different types of sensors from which you can determine what is the best placement
for your space.
A. Keypad B. Alarm system
1. Front door: Magnet contact
2. Living area:
PIR motion detector
3. Window: living area: Magnet contact
4. Window: living area: Magnet contact
Magnet contact
5. Terrace door:
Magnet contact
6. Window :
PIR motion detector
7. Bedroom:
Gas detector
8. Kitchen:
05
X330-UM-EN-FR-ES-PT-V1.0.indd 5-6
C. Siren
The system has four modes for the sensors. The entrance delay zone, normal zone,
home mode zone, and 24 hour zone.
Entrance delay zone:
It is recommended to set the door/window contact as entrance delay zone. When the
system is disarmed, the alarm panel will sound "Dingdong" once the door/window
contact is triggered. If entrance delay time is set, the sensor will delay to alarm when it
is triggered.
Normal zone:
The supplied door/window contact is by default setting on the normal zone. In the
normal zone setting, a sensor is always activated when the alarm is armed.
Home mode zone:
All the sensors in normal zone are armed except those in home mode zone which are
disarmed so that user can move freely at home.
24 hour zone:
The 24 hour zone is default setting for sensors which can detect smoke or gas for
instance. The sensor in this zone is always active and will always send a signal to the
control panel when triggered, regardless whether the system is armed or disarmed
without delay.
Model No.
DS2300
MD9100
You can change the zone mode of sensors from App-[Accessory]-[Wireless Sensors].
EN
Zone mode type (default setting)
Normal zone
Home mode zone
06
2016/8/19 15:41:06