Smanos X330 Mode D'emploi page 20

EN
DS2300 Wireless Magnet Contact
Power supply
Stand-by current
Alarm current
Wireless transmitting distance
Radio frequency
Housing material
Temperature
Relative humidity
Dimensions transmitter
Dimensions magnet
RE2300 Wireless Remote Control
Power supply
Transmit current
Wireless transmitting distance
Radio frequency
Housing material
Temperature
Relative humidity
Dimensions
Electrical products should not be discarded with household products. According to the
European Directive 2002/96/EC on waste electrical and electronic equipment and its
implementation into national law, electrical products used must be collected separately
and disposed of at collection points provided for this purpose.
Talk with your local authorities or dealer for advice on recycling.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT BATTERY TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
33
X330-UM-EN-FR-ES-PT-V1.0.indd 33-34
DC 3V(CR2032 lithium cell battery x 2)
<1uA
<10.5mA
Maximum of 80 m (open field/no interference)
868MHz or 915MHz
ABS Plastic
0°C~+55°C
<80% (non-condensing)
72.5 x 28 x 10 mm (L x W x H)
58 x 14 x 9.5 mm (L x W x H)
DC 3V(CR2032 lithium cell battery x 1)
<9.5 mA
Maximum of 80 m (open field/no interference)
868MHz or 915MHz
PC+ABS plastic
0°C~+55°C
<80% (non-condensing)
71 x 38 x 12 mm (L x W x H)
Troubleshooting
When the alarm system is not working properly please try following solutions:
Problems
Confirm if the power supply is connected correctly
The control panel
cannot start up
Make sure the power is on
Check if the indicator on the remote control is on when pressing a button
Check if the remote control has been paired to the control panel
Remote control
successfully
does not work
The distance between the control panel and the remote control is too
far away
Check whether the LED indicator is on when magnet separates from
transmitter
Door/window contact is too far away from the control panel
Door/window
contact does not
work
Check whether the system is in armed state
Check whether the space between the magnet and transmitter is
within 1 cm
Press the test button of the detector continuously in armed state. If the
control panel does not alarm, please re-pair the PIR to the control panel
The PIR detector
The detector is too far away from the control panel
is triggered but
the control panel
does not alarm
Check if the detector has entered sleeping state
Check if the battery is exhausted
Reason/Solution
34
2016/8/19 15:41:14
EN