PERFECTPRO Workbox Mode D'emploi page 18

Presetting stations – FM/AM
You may store your preferred FM radio stations to the preset
station memories. There are 5 memory presets in your radio 5
each for FM, FM2 and AM. Presets are memorized by your radio
in the event of a power failure.
The procedure for setting presets and using them to tune stations
is the same for FM and AM mode, and is described below.
. Press the Power button to switch on the radio.
2. Press the Source button to select the FM (1 and 2)/AM
waveband.
3. Tune to the required station as previously described.
4. Press and hold the required Preset button until the radio beeps
and the preset number (e.g. P2) will show on the display. The
station will be stored under the chosen preset button. Repeat
this procedure as needed for the remaining presets. Stations
stored in preset memories may be overwritten by following the
above procedure.
GB
6