PERFECTPRO Workbox Mode D'emploi page 15

Operating your radio – FM/AM auto-tune
. Straighten up the antenna.
2. Press the Power button to switch on your radio.
3. Press and release the Source button until the FM (1 or 2)/AM
band is selected.
4. Rotate the Tuning control in a clockwise direction. The displayed
frequency will increase. Then press the Tuning control to carry
out an auto-tune. Your radio will scan up the FM/ AM band from
the currently displayed frequency and will stop scanning when it
finds a station of sufficient strength.
To scan down in frequency, rotate the Tuning control in a anti-
clockwise direction first and then press the Tuning control.
Your radio will scan down the FM/AM band from the currently
displayed frequency and will stop scanning when it finds a
signal of sufficient strength.
5. After a few seconds the display will update. The display will
show the frequency of the signal found.
6. To find other stations press the Tuning control as before.
When the end of the waveband is reached, your radio will
recommence tuning from the opposite end of the waveband.
7. Adjust the Volume to the required setting.
8. To switch off your radio, press the Power button.
Note:
If you find the reception is poor, try repositioning the antenna.
3