Document Processor - Olivetti d-Copia 1600 Mode D'emploi

Optional Equipment

Document Processor

7-2
The Document Processor automatically feeds one-sided originals one by
one for scanning. It also reverses two-sided originals automatically for
duplex copying and split copying.
Originals that can be used with the Document Processor
• Sheet originals only.
• Single-sided originals that have a paper weight within the range of
2
45 g/m to 160 g/m
Two-sided originals that have a paper weight within the range of
2
50 g/m to 120 g/m
• Sizes: Ledger to Statement, Oficio 2, A3 to A5R, Folio
• No. of Sheets that can be loaded:
50 sheets (50 to 80 g/m
(Note, however, that when in Mixed Size Mode, this number is
reduced to 30 sheets.)
Notes on acceptable documents
Be sure NOT to use the following as originals in the Document Processor.
In addition, originals with punched holes or perforations should be set so
that the edge of the paper with the holes or perforations is facing away from
the direction of insertion into the Document Processor.
• OHP film or other transparencies.
• Soft originals such as carbon or vinyl paper, or other originals that
are curled, wrinkled or creased.
• Irregularly shaped originals, wet originals, or originals that have
adhesive tape or glue on them.
• Originals bound with clips or staples. (If you must use such originals,
be sure to remove the clips or staples, and straighten any curls,
wrinkles or creases, before setting them in the Document Processor.
Failure to do so may result in the originals being misfed.)
• Originals with cut-out sections or that have a slippery surface on
either side.
• Originals on which any correction fluid is still wet.
• Originals with strong folds. (If you must use such originals, be sure to
smooth out the folds before setting them in the Document Processor.
Failure to do so may result in the originals being misfed.)
• Originals with sharp curves (when use of a curved original is
unavoidable, straighten out the curves before setting it).
2
.
2
.
2
)
OPERATION GUIDE