Department Id Code Registration; Deleting Department Id Codes - Olivetti d-Copia 1600 Mode D'emploi

Department ID Code Registration

Deleting Department ID Codes

OPERATION GUIDE
3 After completing each setting, press
to display 00.Set Completed.
4 Press [OK].
A Department ID Code of up to 8 digits can be entered.
1
Display the Job Accounting. (Refer to Job Accounting Operations
Procedures on page 6-2.)
2 Press or to display 02.Register
code.
3 Press [OK].
4 Input the Department ID Code to be registered (up to a maximum of 8
digits) using numeric keys.
Number from 0 to 99999999 can be input.
NOTE:
If a mistake is made during input it can be cleared by pressing
[Stop/Clear] and the value reentered.
5
Press [OK]. The code that was input will flash on and off.
6
After confirming the code that was input, press [OK]. The display will return
to that of Step 2.
NOTE:
If an existing Department ID Code is attempted to be registered,
an error will occur and Already registered. will display in the
message display. In this case, register a different Department ID Code.
Deleting a registered Department ID Code.
1 Display the Job Accounting. (Refer to Job Accounting Operations
Procedures on page 6-2.)
2 Press or to display 03.Delete
code.
Job Accounting
or
Job Accounting:
00.Set Completed
Job Accounting:
02.Register code
Job Accounting:
03.Delete code
6-3