Logo Placement; Aluminum Extrusion Trim Kit Installation - Continental Fireplaces CDIZC-N Instructions D'installation Et D'opération

16
4.5

LOGO PLACEMENT

Remove the backing of the logo supplied and place on the glass viewing door,
EN
as indicated.
4.6

ALUMINUM EXTRUSION TRIM KIT INSTALLATION

In order to close off the fi replace opening or if the opening is larger than the 3- or 4-sided aluminum extrusion
trim kits, it is recommended to reduce the opening using a noncombustible material such as ceramic tile,
marble, etc or the GIZBP6-3 or GIZBP6-4 backer plate kits. The outside edge of the backer plate is fi nished
off with gold trim included in each kit. A deluxe fl ashing kit complete with marquis trim may also be used to
complete the installation. These fl ashing and trim combinations are available in 6 inch (152.4mm) and 9 inch
(228.6mm) widths as well as many fi nishes to accent any room decor. Mounting brackets, GIZBRKT, are
required to install the deluxe fl ashing. Detailed installation instructions are included with each kit.
If this appliance is being installed into an existing wood burning, zero clearance fi replace, then be aware of this
precaution: Any circulation air opening may be covered (with noncombustible material) but not sealed!
The appliance can be equipped with either a 3- or 4-sided trim kit to fi nish off the
fi replace opening. Slide the trim assembly over the keyholes (2 per side) and
drop into place. If installing the optional 3- or 4-sided backer plate (GIZBP6-3
or GIZBP6-4), it must be hung prior to the trim kit installation using the same
keyholes.
To adjust the trim: If the mitre is out of alignment, open each side and loosen
the two screws at either side trim hinge. Slide the trim up or down to adjust and
re-tighten screws. There is also a very slight in/out adjustment that can be made.
Note: Since the side panels open and close, to access the controls, a gap is
necessary at the mitre joint.
The top trim piece has an adjustable securing bracket which enables the trim to be
secured to the fi rebox shell.
W415-1404 / 10.15.14
FIRE VIEWING DOOR
VALVE
CONTROL
DOOR
½"
(12.7mm)
LOGO
97.1A
SLIDE TO
ADJUST
LOOSEN
SCREWS
½"
(12.7mm)