1.
Place log #1 snug against the back wall,
PLACE TEXT BOX HERE.
ensuring the notch fi ts around the pilot shield.
NOTE: ENSURE NOMENCLATURE IS
CONSISTENT THROUGHOUT.
3.
Place the two holes in log #2 on B1 and B2.
PLACE TEXT BOX HERE.
Do not cover any burner ports.
NOTE: ENSURE NOMENCLATURE IS
CONSISTENT THROUGHOUT.
5.
Place log #5 on the right-side notch of log #1
PLACE TEXT BOX HERE.
and the two notches of log #2.
NOTE: ENSURE NOMENCLATURE IS
CONSISTENT THROUGHOUT.
2.
Place the two holes in log #3 on A1 and A2. Do
PLACE TEXT BOX HERE.
not cover any burner ports.
NOTE: ENSURE NOMENCLATURE IS
CONSISTENT THROUGHOUT.
4.
Place log #4 on the left-side notch of log #1
PLACE TEXT BOX HERE.
and the two notches of log #3.
NOTE: ENSURE NOMENCLATURE IS
CONSISTENT THROUGHOUT.
6.
Place log #6 along the left side of the lower
PLACE TEXT BOX HERE.
media tray.
NOTE: ENSURE NOMENCLATURE IS
CONSISTENT THROUGHOUT.
fi nishing
EN
15
W415-4001 / 08.11.21