Table des Matières
Publicité
CAUTION: Ensure the jug is cold before removing it from the base. Or, if removing with care, rinse with cold water immediately to
cool down the jug and avoid burning risks.
CAUTION: In case the base needs to be cleaned unplug it first and use only a damp cloth. Make sure the connector is
dry before operation. Do not immerse the base in water neither put in the dishwasher.
of the jug is wet, dry it before putting it back in contact with the base connector.
cleaning materials. Do not use abrasives, sharp objects, brushes: risk of scratches and harm to the jug coating.
TROUBLESHOOTING
Aeroccino does not start
Quality of milk froth not up to standard
Red Button blinking
Milk Overflows
SPECIFICATIONS
9182_UM_AEROCCINO3_Z2_JAB.indd 9
CAUTION: Do not immerse neither the jug nor the base in the water.
➔ Be sure to position the jug correctly on a clean base. Be sure to attach the whisk to the jug correctly
➔ Be sure to use whole or semi-skimmed milk at refrigerated temperature (about 4-6° C)
➔ Be sure to use the appropriate whisk and the jug is clean
➔ a) The appliance is too hot. Rinse it under cool water b) Whisk is missing c) Not enough milk. Fill milk frother up to one of the
two «max» level
➔ Be sure to use the appropriate whisk and check the corresponding indicator level
3694
CAUTION: If the bottom part
CAUTION: Only use non-abrasive
EUR: 220-240 V, 50-60 Hz, 430-500 W
EN
9
24.04.17 15:11
Publicité
Table des Matières
