Commandes Et Indicateurs; Face Avant Du Moniteur; Alarm Indications - Welch Allyn RPM-BP100 Mode D'emploi

18 Use the monitor
Problem Symptom
The display indicates the "0-
Low batteries
LO" message, pauses for 3
seconds. The battery icon
shows empty (does not
flash.)
E 01 shows
Error messages
E 02 shows
E 03 shows
E 10 or E 11 shows
E 20 shows
E 21 shows

Alarm indications

Symptom Root cause
Out of range. Either SYS > 230mmHg or DIA
> 130mmHg. The symbol may appear in
either the SYS or DIA area of the screen.
Welch Allyn Remote Monitoring Blood Pressure Device RPM-BP100
Root cause Solution
Insert the AC adaptor tightly
AC adaptor is inserted
incorrectly.
Batteries are low. Replace with new batteries
The cuff is not secure Readjust the cuff, relax for a
moment, and then measure
again
The cuff is very tight Refasten the cuff and then
measure again
There is too much pressure in Refasten the cuff and then
the cuff measure again
The monitor detected motion Relax for a moment and then
while measuring measure again
The measurement process Loosen the clothing on the
does not detect a pulse arm and then measure again
signal
Measurement incorrect Relax for a moment and then
measure again
Solution
Power
Press and hold the button to
reestablsh the Bluetooth connectivity.
Measure again. If the problem persists,
contact your physician.
Alarm priority = Low !
Mode d'emploi

Commandes et indicateurs

Face avant du moniteur

N° Fonction
1 Brassard (appareil de type BF)
2 Tuyau d'air
3 Prise du connecteur d'air
4 Bouton d'alimentation
5 Écran LCD
Informations de présentation
Description
S'attache au bras du patient.
Connecte le brassard à la prise du connecteur d'air.
Le tuyau d'air se connecte à la prise du connecteur d'air.
Met le moniteur sous tension, démarre la mesure de pression
artérielle et, quand maintenu enfoncé, initie un appariement
Bluetooth.
Affiche la lecture de la pression artérielle et d'autres
informations pertinentes sur la lecture.
7