Roco BR 03.10 Série Manuel page 26

Please note! To achieve proper mounting of the
enclosed etched labels will you please follow
these instructions:
As delivered the etched label surface is comple-
tely covered with paint. To make the metal num-
bers and letters visible the paint must be remo-
ved from the actual letter and numeral surfaces:
this is done as follows:
1. Before removing the labels from the etched frame place them with their backs on a firm and com-
pletely level surface.
2. Remove the paint from the surface of the characters carefully either with the ROCO rubber (art. no.
10002) a sharp knife having a straight edge or similar
object (e.g. single-edge razor blade). Take care that while doing this the paint surface between the
characters is not damaged.
3. If the result is not satisfactory it is recommended that the remaining paint is removed with a suitab-
le paint remover. Thoroughly dry the labels and then
reapply fresh paint. Repeat the removal of the paint from the surface of the characters after the new
paint is completely dry.
4. Carefully extract the different labels from their etching frames and remove any remaining burrs.
5. Attach the etched labels with very small amounts of adhesive on top of the printed signs on the
vehicle.
Cement
26 26
26 26
8072207920.indd 26
Working with etched Labels
25.02.2015 10:33:35