Xylem SI Analytics SLR Mode D'emploi page 25

Actual temperature 24° C
Residual-heat indicator "HOT"
Switching off the heater

Press and hold the right control knob for approximately
2 seconds until the heating display disappears.
 The heater is now switched off.
 The residual-heat indicator "HOT" continues to light up as
long as the glass-ceramics heating zone is still hot.
CAUTION! Residual heat!
Do not touch the heating zone!
 The
installed ventilator
heating zone has cooled down completely.
CAUTION! Risk of overheating!
Do not pull out mains plug!
Disconnecting the device from mains
Do not unplug the stirrer before the heating zone has completely
cooled down and the ventilator has switched off. To disconnect the
device from the mains, pull out mains plug.
Initial Operation 25
continues to operate until the