Operating Heater Without Temperature Sensor - Xylem SI Analytics SLR Mode D'emploi

3.2 Operating heater without temperature sensor

Switching on the heater
Selecting a heating stage
Heating stage 015
Residual-heat indicator "HOT"
Switching on the heater

Press and hold the right control knob for approximately
2 seconds until the heater display appears

The display shows heating stage "0" (zero).

Select your desired heating stage within 30 seconds.

After 30 seconds the heater switches off again if you do not
select a heating stage (safety function).
Selecting a heating stage
If the heater is operated without a temperature sensor, the heating
energy will be controlled.

Select the desired heating stage using the right control knob
(turn clockwise to switch to a higher heating stage).
The maximum heating stage is 024.

The selected heating stage is shown on the display.

The bar graph indicates the heating activity of the heater.

The heater heats up until the selected temperature level is
achieved.
CAUTION! Risk of burning!
Do not touch the heating zone!

After having operated at heating stage 024 for 3 hours, the
heater switches back to heating stage 018 (safety function)
Switching off the heater

Press and hold the right control knob for approximately
2 seconds until the heating display disappears.

The heater is now switched off.

The residual-heat indicator "HOT" continues to light up as long
as the glass-ceramics heating zone is still hot.
CAUTION! Residual heat!
Do not touch the heating zone!

The installed ventilator continues to operate until the heating
zone has cooled down completely.
CAUTION! Risk of overheating!
Do not pull out mains plug!
Disconnecting the device from mains
Do not unplug the stirrer before the heating zone has completely
cooled down and the ventilator has switched off. To disconnect the
device from the mains, pull out mains plug.
Initial Operation 23