Waypoint - Saving Receiver's Location; Beeper Feature - Dog trace X30 Mode D'emploi

Turning off FENCE:
1. Select the dog number for which you wish to disable FENCE on the main
navigation panel.
2. Press and hold the FENCE push button.
3. Set OFF by
4. Press briefly
8.5 WAYPOINT – saving receiver's location
The waypoint feature enables saving the GPS coordinates of the current receiver
(handset) location. Subsequently, you may navigate to the saved location.
Saving waypoint:
1. Hold the CODE push button on the receiver for 2 seconds.
2. Select position to which you wish to save the waypoint by
position is empty (at given position there is no paired transmitter, other receiver
or saved waypoint), the
3. Hold the MENU push button for 2 seconds to show
4. Press the
To navigate to the saved waypoint, select in the main navigation panel by
arrows the saved location.
Deleting waypoint:
1. Switch off all transmitters (collars) in the receiver vicinity.
2. Hold the CODE push button on the receiver for 2 seconds.
3. Select position you wish to delete by
4. Hold the CODE push button for 2 seconds – after approximately 20 seconds the
5. Press the
WARNING: By saving the waypoint to a position where you have a paired
transmitter or other receiver, will delete the transmitter (receiver) from the
receiver's memory.

8.6 BEEPER feature

The BEEPER feature is mainly used by gamekeepers/hunters to distinguish the
intensity of movement or the presence of a dog near wild pig.
If the transmitter (collar) is turned on and the dog is in motion, the BEEPER message
flashes in the main navigation window on the receiver display. If the dog does not
move or is near wild pig, the BEEPER is lit continuously. In the top line of the display,
the BEEPER indicates status when the sound or vibration indication is selected for at
least one dog on the receiver.
Setting the BEEPER feature:
The BEEPER feature must be set correctly before hunting commences.
1. Long press the MENU push button, select
holding the MENU push button.
2. Select the transmitter (collar) for which you wish to set BEEPER. Long press the
MENU push button.
20
/ arrows.
to return to the main screen.
push button to return to the main screen.
message is displayed.
push button to return to the main screen.
message is shown on the display.
/ arrows.
and confirm by pressing and
/ arrows. If the
.
/