Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Daily use
WARNING!
Refer to Safety chapters.
Activating and deactivating
Touch
for 1 second to activate or deactivate
the hob.
Automatic Switch Off
The function deactivates the hob
automatically if:
• All cooking zones are deactivated.
• You do not set the heat setting after you
activate the hob.
• You spill something or put something on the
control panel for more than 10 seconds (a
pan, a cloth, etc.). An acoustic signal sounds
and the hob deactivates. Remove the object
or clean the control panel.
• The hob gets too hot (e.g. when, a saucepan
boils dry). Let the cooking zone cool down
before you use the hob again.
• You use incorrect cookware. The symbol
comes on and the cooking zone deactivates
automatically after 2 minutes.
• You do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the hob deactivates. See
below.
The relation between heat setting and
times of the function:
•
, 1 - 2— 6 hours
• 3 - 4 — 5 hours
• 5 — 4 hours
• 6 - 9 — 1.5 hours
The heat setting
Touch
to increase the heat setting. Touch
to decrease the heat setting. Touch
at the same time to deactivate the cooking
zone.
Automatic Heat Up
If you activate this function you can get a
necessary heat setting in a shorter time. The
function sets the highest heat setting for some
time and then decreases to the correct heat
setting.
www.zanussi.com
To activate the function the cooking
zone must be cold.
To activate the function for a cooking
zone: touch
touch
(
until the correct heat setting comes on. After 3
seconds
To deactivate the function: touch
Power function
This function makes more power available to the
induction cooking zones. The function can be
activated for the induction cooking zone only for
a limited period of time. After this time the
induction cooking zone automatically sets back
to the highest heat setting.
Refer to "Technical information"
chapter.
To activate the function for a cooking
zone: touch
To deactivate the function: touch
Timer
Count Down Timer
You can use this function to set how long the
cooking zone operates for only this one time.
First set the cooking zone then set the
function. You can set the heat setting before
or after you set the function.
To set the cooking zone: touch
again until the indicator of a necessary cooking
zone comes on.
To activate the function or change the
time: touch
and
time (00 - 99 minutes). When the indicator of
the cooking zone starts to flash slowly the time
counts down.
To see the remaining time: set the cooking
zone with
starts to flash quickly. The display shows the
remaining time.
(
comes on). Immediately
comes on). Immediately touch
comes on.
.
comes on.
or
of the timer to set the
. The indicator of the cooking zone
.
or
.
again and
23
Publicité
Chapitres
Table des Matières
