Cleaning Thoroughly - Panasonic ES‑LV9Q Mode D'emploi

Cleaning thoroughly

Cleaning with water
• Turn the shaver off and disconnect the AC adaptor.
1
Apply some hand soap and some
water to the system outer foil�
2
Press for more than
2 seconds to activate the sonic
vibration cleaning mode�
• Splashing of foam is suppressed.
• The battery capacity lamps blink in order.
• After about 20 seconds, it will be
automatically turned off, or you can turn
it off by pressing the power switch.
3
Remove the outer foil section
and clean with running water�
• See page 18 for attaching and
removing the outer foil section.
• Splashing is reduced by rinsing the
shaver in sonic vibration cleaning mode.
• After rinsing with water, shake the shaver up and down for a
few times to remove excess moisture and then wipe off any
drops of water with a dry cloth.
16
ES-LV9Q_US.indb 16
4
Attach the outer foil section
and dry with the self-cleaning
recharger�
1. Insert the shaver into the self‑
cleaning recharger and plug the
adaptor into a household outlet.
• Check that the charge status lamp
( ) is glowing.
2. Press twice.
The DRY lamp glows, and the "Dry/Charge" mode will start
after approximately 6 seconds.
• It is possible to change to the "AUTO" mode even after
the "Dry/Charge" mode has started.
Dry
180 min
3. Remove the adaptor after the selected mode is completed.
5
Lubricate the shaver�
It will keep the movement of the blade
smooth and maintain a comfort shave.
1. Apply one drop of oil to each of the
system outer foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately fi ve seconds.
4. Switch off the shaver, and wipe off any excess oil from the
system outer foil with a soft cloth.
1
1
2
Charge
0 to 60 min
2018/03/02 15:51:17