Panasonic ES‑LV9Q Mode D'emploi page 21

►Self-cleaning recharger
Problem
The blade has not been
thoroughly washed.
The blades are not dry or
are sticky.
The blades crack or
deform during cleaning.
ES-LV9Q_US.indb 21
Action
If the shaver is not cleaned for
more than 2 weeks, first clean
with the cleaning brush to remove
beard trimmings.
(See page 17.)
Do not add detergent and water
except when replacing the
cleaning liquid.
Doing so may deteriorate the
cleaning function.
(See page 19.)
After cleaning, oil‑like droplets may
remain on the outside of the foil
frame. This is the lubricating
component of the cleaning liquid
and does not indicate a problem.
You may wipe it off with a soft cloth.
The blades may not dry quickly
due to temperature conditions.
Run the "Dry/Charge" mode again or
wipe with a soft cloth before shaving.
Do not insert any foreign objects
into the recharger.
Replace the system outer foil and/
or inner blades. (See page 17.)
Problem
If you mix soapy water or hand
soap with the detergent or use
another detergent, the cleaning
liquid will foam. Use the self‑
The cleaning liquid has
cleaning recharger after
foamed.
thoroughly washing and drying
the shaver.
Replace the cleaning liquid.
(See page 18.)
Remove any waste, etc. that has
accumulated in the drain at the
bottom of the cleaning tray.
(See page 19.)
Cleaning liquid has
accumulated in the
If you use the self‑cleaning
cleaning tray.
recharger when the shaver is wet
or when soap or shaving gel is on
the shaver, cleaning liquid may
accumulate in the cleaning tray.
Do not press the cleaning liquid unit
removal button during any mode.
Place the self‑cleaning recharger
horizontally.
Cleaning liquid leaked from
If you use the self‑cleaning
the cleaning liquid unit.
recharger when the shaver is wet
or when soap or shaving gel is on
the shaver, cleaning liquid may
leak.
Place the self‑cleaning recharger
The cleaning liquid unit
on a hard, flat surface.
cannot be removed.
(See page 12.)
Action
21
2018/03/02 15:51:19