Panasonic ES‑LV9Q Mode D'emploi page 22

Problem
The mode does not start.
The shaver cannot be
charged.
22
ES-LV9Q_US.indb 22
Action
Check that the AC adaptor is
connected to the self‑cleaning
recharger, and that the adaptor is
plugged in to a household outlet.
(See page 15.)
Confirm that the shaver is
properly attached to the self‑
cleaning recharger.
(See page 15.)
The Clean or Dry function may
not operate under extreme low
temperatures (approximately 0 °C
(32 °F) or lower).
Check if the STATUS lamp is
glowing. (See page 19.)
Gently wipe the main body rear
terminals and the charging
terminals of the self‑cleaning
recharger with a cloth or tissue
dampened with water.
Problem
During cleaning:
After cleaning:
Makes a loud sound.
The sound after cleaning is different
from the sound during cleaning.
The water level has dropped and it
is removing water droplets from the
blades after cleaning. This does not
indicate a problem.
►Shaver
Problem
The appliance may not unlock
depending on usage conditions.
Place the appliance on the desk,
The power switch does
then pick it up again. If it still does not
not turn ON.
operate, press and hold the power
switch for more than 2 seconds to
forcibly unlock the appliance.
The clean lamp ( )
Please clean the blades with the
glows.
self‑cleaning recharger or the
(It turns off in about
sonic vibration cleaning mode.
1 minute.)
Action
The self‑cleaning recharger
makes a loud sound due to the
cleaning of the blades.
The self‑cleaning recharger
makes a loud sound due to the
removal of water droplets in
order to speed drying.
Action
2018/03/02 15:51:19