Blumfeldt Goldflame Style Mode D'emploi page 42

EN
42
1. Fix both velcro tapes onto rear of tank housing using preassembled four
M5x12 screws, Ø5 washers, M5 nuts.
2. Position a gas cylinder inside the tank housing.
3. Close the gas cylinder tap, then connect the gas cylinder with a regulator.
Please refer to the instructions attached with the regulator on how to
connect a regulator with the gas cylinder.
4. Loop the Velcro tapes around the gas cylinder and fasten them together
with the Velcro fasteners (see illustration above). The Velcro tapes must
be sufficiently tight against the gas cylinder.
Note: Please take care that the velcro tapes, do not strain the regulator
assembly!
CAUTION
Risk of fire!
leak is found, tighten the joint and then re-test.
Check for leaks at all joints using soapy water. If a