Blumfeldt Goldflame Style Mode D'emploi page 33

17
Line up holes on the bracket of wheel assembly (17) with the corresponding
holes on base, then insert two M8 x 16 mm bolts (DD) through holes. Hand
tighten with two M8 flange nuts (EE).
Secure three base stands to the base using preassembled six M5 x 14 mm
bolts, Ø5 washers and lock washers.
To improve stability, the preassembled water box of tank housing assembly
can be filled with sand (not included).
14
Keep the burner with the igniter side up. Fix the burner assembly (15) to
table (14) using four M5x12 mm screws (FF)..
Step 1
Step 2
15
Fill sand
EN
33