Blumfeldt Goldflame Style Mode D'emploi page 43

Leak testing
WARNING
Risk of explosion! Never use a naked flame to check for leaks.
Never smoke during a leak test.
• The gas connections on
this appliance are leak
tested at the factory prior
to shipment.
• This appliance needs
to be periodically
checked for leaks and
an immediate check is
required if the smell of
gas is detected.
• Make a soap solution
using 1 part of liquid dish-
washing soap to 3 parts
water. The soap solution
can be applied with a soap
bottle, brush, or rag to the
leak tested points shown
in the figure (right).
• The valve of the gas
cylinder should be in
the "OFF" position at
this point of the leak test. Once the soapy solution is applied to the gas
connections, the valve of the gas cylinder needs to be turned to the
"ON" position.
• Soap bubbles will begin to form in the soapy solution if a leak is present.
• In case of a leak, turn off the gas supply. Tighten any leaking fittings, then
turn the gas supply on and recheck.
EN
43