Safety Instructions - Blumfeldt Goldflame Style Mode D'emploi

EN
28

SAFETY INSTRUCTIONS

• Please read the instructions carefully before installation and use of the
appliance and keep the manual for future reference.
• This appliance must be used outdoors or in a well ventilated area, and
should not be installed or used indoors.
• Change the gas cylinder in a well ventilated area, away from any
inflammation sources.
• The cylinder must be stored outdoors or in a well ventilated area.
• Storage this appliance indoors is permissible only if gas cylinder is
disconnected and removed from the appliance.
• Do not move this appliance when in operation, or after it has been turned
off before the temperature has cooled down.
• Do not attempt to alter the appliance in any manner. Do not paint the
radiant screen, control panel or reflector
• Do not obstruct the ventilation holes of the cylinder housing.
• The appliance must be installed and gas cylinder stored in accordance with
local gas fitting regulations.
• Shut off the valve at the gas cylinder or the regulator before moving the
appliance.
• Repairs should be done by a qualified person.
• In case of violent wind, particular attention must be taken against tilting of
the appliance.
• Check that the regulator seal is correctly fitted and able to fulfil its
function.
• Close the gas supply at the valve of the gas cylinder or the regulator after
use.
• Do not use this appliance until all connections have been leak tested.
• In the event of gas leakage, the appliance shall not be used or if alight, the
gas supply shall be shut off and the appliance shall be investigated and
rectified before it is used again.
• Check the tubing or the flexible hose at least once per month and each
time the cylinder is changed.
• The tubing or the flexible hose must be changed within the prescribed
intervals or within one year.
• The hose assembly must be replaced prior to the appliance being put
into operation if there is evidence of excessive abrasion or wear, or if the
hose is damaged, and that the replacement hose assembly shall be that
specified by the manufacturer.
• The heater should be inspected before use and at least annually by
a qualified service person. More frequent cleaning may be required
as necessary. It is imperative that control compartment, burners and
circulating air passageways of the appliance be kept clean.