Component Replacement; Cover Panel; Combustion Fan; Hopper Lid Safety Switch - England's Stove Works 21-PG100 Instructions

COMPONENT REPLACEMENT
(WARNING: As with any maintenance concerning this unit, be sure the unit is "OFF" and has
completed the Shut‐Down cycle BEFORE beginning. Unplug the unit. Be aware that metal
parts can remain HOT long after the fire has gone out and EVEN after the Shut‐Down cycle is
complete. Always use extreme caution when handling potentially hot parts, even if you think
they should be cold.)
Cover panel
To remove the cover panel: Using a 5/16" socket, loosen and remove the six screws on the
cover panel, then slide the panel out and set aside. When finished with any trouble shooting or
component replacement, reinstall the panel in the reverse of this method.
Refer to this illustration for the procedures on this page
Combustion fan
Remove the cover panel. Unplug the wires from the fan. Lift the fan up and then remove.
*Because the ground wire is attached to the unit on the combustion chamber, it may be
necessary to loosen this screw to remove the combustion fan. To install the new fan, use the
reverse of this method, being sure to install the fan in the correct direction (with the fan
blowing into the chamber).
Hopper lid safety switch
Loosen the ½" nut, and then remove the nut and washer. Unplug the wires from the switch,
taking note of where the wires are connected. To install the new switch, connect the wires to
the new switch and then place the switch button into the hole and install the nut and washer,
being careful not to over‐tighten.
Auger motor/Auger
*Be sure to remove all the pellets from the hopper before trying to remove the auger or auger
motor.* Remove the cover panel. Unplug the auger motor wires from the wiring harness.
(Continued next page.)
15