Check Operation - Frigidaire FFGW2416UB Instructions D'utilisation

GAS WALL OVEN INSTALLATION INSTRUCTIONS
Observe the oven burner flame to determine if it is
right. It should be steady with a blue cone approxi-
mately 1" long and should not extend out over the
edges of baffle. For LP Gas, this will most likely
occur when the air adjustment shutter is completely
open.
Turn Oven Temperature to 300°F and allow oven
burner to cycle on and off.
To replace storage drawer, reverse steps taken for
removal (see the Use and Care Guide for complete
instructions). Replace oven racks.
11. Check Operation
Refer to the Use and Care Guide packaged with
the wall oven for operating instructions and for care
and cleaning of your appliance.
Do not touch the oven burners. They may be hot
enough to cause burns.
1. Check the Igniters (some models)
Operation of electric igniters should be chec-
ked after oven and supply line connectors have
been carefully checked for leaks and oven has
been connected to electric power.
2. Oven Igniter System
Close the door and turn the Oven Temperature
to 300°F. In approximately 60 seconds, the bur-
ner should ignite and stay on until oven reaches
300°F. Burner should then cycle on and off to
maintain an average temperature of approxima-
tely 300°F.
When All Hookups are Complete
Make sure all controls and programmable timer are
left in the OFF position.
Reset all controls to the "OFF" position after using
a programmable timing operation.
Model and Serial Number Location
The serial plate is located on the left side inner trim
of the oven.
When ordering parts for or making inquires about
your wall oven, always be sure to include the model
and serial numbers and a lot number or letter from
the serial plate of your appliance.
Your serial plate also tells you the rating of the
burners, the type of fuel and the pressure the wall
oven was adjusted for when it left the factory.
• Stepping, leaning or sitting on the oven door
or drawer can result in serious injuries and
also cause damage to the appliance.
• Be sure to keep appliance clear of com-
bustible materials, gasoline and other flam-
mable vapors and liquids.
Before You Call for Service
Read the Avoid Service Checklist and operating
and cleaning instructions in your Use and Care
Guide.
Check to make sure the house fuse or circuit brea-
ker for your wall oven is not blown or open.
Care, Cleaning and Maintenance for Wall Ovens
If removing the wall oven is necessary for cleaning
or maintenance, shut off gas supply. Disconnect
the gas and electric supply. Remove the installation
screws from front frame and lower trim. Pull out
only as far as necessary to disconnect the electric
supply line. After disconnecting the gas and electric
supply, finish removing the unit for servicing and
cleaning. Reinstall in reverse order and make sure
that appliance is level; check gas connection for
leaks.
9