Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GAS WALL OVEN INSTALLATION INSTRUCTIONS
To adjust oven height:
1. Lay oven on its back (see Figure 6).
2. Remove the 3 screws that fasten the side ex-
tension panel to the bottom sides of the oven.
3. Move each panel down to the position that
increases the oven height to fit your opening.
Each position changes oven height approxima-
tely ½".
4. Line up the appropriate holes in the side exten-
sion panels and sides of the oven. Put the 3
screws back.
5. Proceed with oven installation. Return to
upright position.
Oven Door
Oven Bottom
Figure 6
5. Cabinet Installation
Insert appliance into cutout. Use the 2 mounting
screws provided to fasten the front frame of the
appliance to the cabinet (steps 1 below). Keep the
6 decorative screws to fix the decorative trim to the
cabinet (step 2 below). The mounting holes in the
front frame of appliance may be used as a template
to locate the appliance mounting screw holes on
the cabinet.
To fasten the appliance to the cabinet (see
Figure 7):
1. Use 2 mounting screws supplied to secure the
2. Install the decorative trim panel to appliance
Extension Panel
Decorative Trim
Decorative Screws
5
appliance to the cabinetry. 2 holes are located
under the center vent trim on each side.
bottom using the 6 supplied screws. Four
screws are installed along the front of the panel.
Two screw are installed at the opper corners of
the panel.
Center Vent Trim
Mounting Screws
Decorative Screws
Figure 7
Publicité
Table des Matières
