Cleaning And Care; Cleaning The Spray Bottle; Washing The Microfibre Cover; Cleaning The Appliance - SilverCrest SFR 3.7 A2 Mode D'emploi

■ To charge the appliance, connect the charger
to a mains socket and insert the connecting jack
into the charging socket
The indicator light
appliance is fully charged, the indicator light
lights up green.
NOTE
► Only recharge the batteries when the suction
power of the appliance is noticeably weaker
and the red indicator light

Cleaning and care

DANGER – ELECTRIC SHOCK!
► Prior to cleaning, disconnect the appliance
from the charger
ATTENTION! DAMAGE TO PROPERTY!
► Do not use abrasive or aggressive cleaning
materials. These could damage the surface
of the appliance!

Cleaning the spray bottle

■ Open the spray bottle and empty contents.
Remove the microfibre cover
Wipe the components of the spray bottle with
a damp cloth; if necessary, use a little mild deter-
gent on the cloth.
Washing the microfibre cover
The microfibre cover
washed at 60°C. Do not use any fabric
conditioner as this significantly reduces the
cleaning power of the microfibres.
Do not bleach the microfibre cover
Do not wring the microfibre cover
SFR 3.7 A2
on the motor unit
lights up red. When the
is flashing red.
! Risk of electric shock!
.
can be machine-
!
!
Do not tumble dry the microfibre cover
.
Do not iron the microfibre cover
Material ingredients:
70% Polyester / 30% Polyamide

Cleaning the appliance

For thorough cleaning, disassemble the appliance:
1) Press the ridged area on the underside of
vacuum attachment
attachment
Clean the vacuum attachment
cloth. If required, use some mild detergent on
the cloth.
2) Press the release buttons
time pull the connecting piece
motor unit
with a damp cloth. If required, use some mild
detergent on the cloth.
3) Remove the dirt container
unit .
Turn the grey nozzle
dirt container
it off. Now you can pull the grey rod down-
wards out of the dirt container
dirt container
sary, with a mild detergent.
4) Wipe the motor block
If required, use some mild detergent on the
cloth. Dry the motor unit.
and pull the vacuum
from the connecting piece
with a damp
and at the same
from the
. Clean the connecting piece
from the motor
at the top end of the
slightly anticlockwise and lift
. Rinse the
with clear water and, if neces-
off with a damp cloth.
GB │ IE
!
!
.
│ 7 ■