•
Reattach the end cap to the brush bar.
•
Slide the large brush bar back onto the cleaner head, around the motor. The
end cap should be in the open position as shown. Once in place, rotate the end
cap back into the closed position.
•
Close the fastener by turning a quarter turn clockwise. Ensure that the fastener is
fully turned and the base plate and the brush bars are secure.
WASHING THE FILTERS
•
Your appliance has two washable filters; wash the filters at least once a month
according to the following instructions to maintain performance. More frequent
washing may be required where the user: vacuums fine dust, operates mainly in
'Powerful suction' mode, or uses the machine intensively.
WASHING FILTER A
•
Ensure the appliance is disconnected from the charger before removing the
filter. Be careful not to pull the 'ON' trigger.
•
Check and wash the filter regularly according to instructions to
maintain performance.
•
The filter may require more frequent washing if vacuuming fine dust or if used
mainly in 'Powerful suction' mode.
•
To remove the filter, lift it out of the top of the appliance.
•
Wash the filter with cold water only. No hot water and no detergents.
•
Run water over the outside of the filter until the water runs clear.
•
Squeeze and twist with both hands to make sure the excess water is removed.
•
Leave the filter to dry completely for a minimum of 24 hours.
•
Do not put the filter in a dishwasher, washing machine, tumble dryer, oven,
microwave or near a naked flame.
•
To refit, place the dry filter back into the top of the appliance. Make sure it is
seated properly.
WASHING FILTER B
•
To remove the filter, twist anti clockwise to the open position and pull away from
the appliance.
•
Wash the inside of the filter under cold running water, rotating the filter to
ensure all pleats are covered.
•
Gently tap the filter against the side of the sink several times to remove
any debris.
•
Repeat this process 4-5 times until the filter is clean.
•
Place the filter upright, with the Max button facing upwards, and leave to dry
completely for a minimum of 24 hours.
•
To refit, return the filter to the open position and twist clockwise until it clicks
into place.
BLOCKAGES – AUTOMATIC CUT-OUT
•
This appliance is fitted with an automatic cut-out.
•
If any part becomes blocked the appliance may automatically cut out.
•
This will happen after the motor pulses a number of times (i.e switches on and
off in quick succession).
•
Leave to cool down before looking for blockages.
•
Ensure the appliance is disconnected from the charger before looking for
blockages. Failure to do so could result in personal injury.
•
Clear any blockage before restarting.
•
Refit all parts securely before using.
•
Clearing blockages is not covered by your guarantee.
LOOKING FOR BLOCKAGES
The motor will pulse when there is a blockage. Please follow the instructions
below to locate the blockage:
•
Ensure the appliance is disconnected from the charger before looking for
blockages. Be careful not to pull the 'ON' trigger.
•
Do not operate while checking for blockages. Doing so could result in
personal injury.
•
Beware of sharp objects when checking for blockages.
•
To check for blockages in the main body of the appliance, remove the clear
bin and cyclone as per the instructions in the cleaning the clear bin section and
remove the blockage. Please consult the 'Stubborn blockages' section of the
illustrations for further guidance.
•
If you cannot clear an obstruction you may need to remove the brush bars,
please follow the instructions below:
– To remove the soft roller cleanerhead brush bars, please refer to the 'Washing
the soft roller cleanerhead brush bars' section. Remove the obstruction and
replace the brush bars as shown in the 'Washing the soft roller cleanerhead
brush bars' section. Ensure that the fastener is fully turned and the base plate
and brush bars are secure before operating the appliance.
– To remove the brush bar from the direct drive cleanerhead, use a coin to
unlock the fastener and slide the brush bar out of the cleanerhead. Remove
the obstruction. Replace the brush bar and secure it by tightening the fastener.
Ensure it is fixed firmly before operating the appliance.
•
This appliance has carbon fibre brushes. Take care if coming into contact with
them, as they may cause minor skin irritation. Wash your hands after handling
the brushes.
•
Refit all parts securely before using.
•
Clearing blockages is not covered by your guarantee.
CHARGING AND STORING
•
This appliance will switch 'OFF' if the battery temperature is below 3 C
(37.4 F). This is designed to protect the motor and battery. Do not charge the
appliance and then move it to an area with a temperature below 3 C (37.4 F)
for storage purposes.
•
To help prolong battery life, avoid recharging immediately after a full discharge.
Allow to cool for a few minutes.
•
Avoid using the appliance with the battery flush to a surface. This will help it run
cooler and prolong battery run time and life.
BATTERY SAFETY INSTRUCTIONS
•
If the battery needs replacing please contact the Dyson Helpline.
•
Use only Dyson chargers for charging this Dyson appliance.
•
The battery is a sealed unit and under normal circumstances poses no safety
concerns. In the unlikely event that liquid leaks from the battery do not touch the
liquid and observe the following precautions:
– Skin contact – can cause irritation. Wash with soap and water.
– Inhalation – can cause respiratory irritation. Expose to fresh air and seek
medical advice.
– Eye contact – can cause irritation. Immediately flush eyes thoroughly with water
for at least 15 minutes. Seek medical attention.
– Disposal – wear gloves to handle the battery and dispose of immediately,
following local ordinances or regulations.
CAUTION
The battery used in this device may present a risk of fire or chemical burn if
mistreated. Do not disassemble, short contacts, heat above 60 C (140 F), or
incinerate. Keep away from children. Do not disassemble and do not dispose of
in fire.
DISPOSAL INFORMATION
•
Dispose of or recycle the battery in accordance with local ordinances
or regulations.
•
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact
the retailer where the product was purchased. They can take this product for
environmental safe recycling.
•
Keep the used batteries away from children as these can still harm children
if swallowed.
•
Dyson products are made from high grade recyclable materials. Recycle
where possible.
•
Your filter unit is non-washable and non-recyclable.
•
The battery should be removed from the product before disposal.
EN
GUARANTEE TERMS AND CONDITIONS
DYSON CUSTOMER CARE
THANK YOU FOR CHOOSING TO BUY A DYSON APPLIANCE
After registering your free 2 year guarantee, your Dyson appliance will be
covered for parts and labour for 2 years from the date of purchase, subject
to the terms of the guarantee. If you have any questions about your Dyson
appliance, call the Dyson Helpline with your serial number and details of where/
when you bought the appliance.
Most questions can be solved over the phone by one of our trained Dyson
Helpline staff.
Alternatively, visit www.dyson.com for online help, general tips and useful
information about Dyson.
If your Dyson appliance needs a service, call the Dyson Helpline so we can
discuss the available options. If your Dyson appliance is under guarantee, and
the repair is covered, it will be repaired at no cost.
PLEASE REGISTER AS A DYSON
APPLIANCE OWNER
To help us ensure you receive prompt and efficient service, please register as a
Dyson appliance owner. There are two ways to do this:
•
Online at www.dyson.com
•
Telephone the Dyson Helpline.
This will confirm ownership of your Dyson appliance in the event of an insurance
loss, and enable us to contact you if necessary.
LIMITED 2 YEAR GUARANTEE
TERMS AND CONDITIONS OF THE DYSON 2 YEAR LIMITED GUARANTEE
WHAT IS COVERED
•
The repair or replacement of your Dyson appliance (at Dyson's discretion) if it
is found to be defective due to faulty materials, workmanship or function within
2 years of purchase or delivery (if any part is no longer available or out of
manufacture Dyson will replace it with a functional replacement part).
•
Where this machine is sold outside of the EU, this warranty will only be valid if
the appliance is used in the country in which it was sold.
•
Where this machine is sold within the EU, this warranty will only be valid (i) if
the appliance is used in the country in which it was sold or (ii) if the appliance is
used in Austria, Belgium, France, Germany, Ireland, Italy, Netherlands, Spain or
the United Kingdom and the same model as this appliance is sold at the same
voltage rating in the relevant country.
WHAT IS NOT COVERED
Dyson does not guarantee the repair or replacement of a product where a
defect is the result of:
•
Accidental damage, faults caused by negligent use or care, misuse, neglect,
careless operation or handling of the appliance which is not in accordance with
the Dyson Operating Manual.
•
Use of the appliance for anything other than normal domestic
household purposes.
•
Use of parts not assembled or installed in accordance with the instructions
of Dyson.
39