Maintenance / Service - Skil F0152770 Série Mode D'emploi

page de 121

/ 121
Matières
Table des Matières
Signets

Table des Matières

Les langues disponibles

7 Do not dispose of the battery together with

household waste material

WHEN CONNECTING NEW 3-PIN PLUG (U.K. ONLY):

• Do not connect the blue (= neutral) or brown (= live) wire

in the cord of the charger to the earth terminal of the

plug

• If for any reason the old plug is cut off the cord of the

charger, it must be disposed of safely and not left

unattended

USE

• On/Off 8

• Speed control for smooth starting 9

• Charging battery 2

! a lithium-ion battery that is new or has not been

used for a longer period does not develop its full

capacity until after approximately 3 charging/

discharging cycles

- plug charger into power source

- light C will turn on GREEN indicating that the charger

is ready for operation

- insert tool into charger

- light C/K will turn RED indicating that the battery is

being charged

- after 3 hours the battery is fully charged and charging

automatically stops (indicator K turns off)

- if the tool is used only briefly, the charging time can

be very short

- unplug the charger when the battery is fully charged

IMPORTANT:

- if light C does not turn RED after inserting tool into

charger, this may mean that the battery is too cold or

too hot; when the battery temperature returns to

between 0°C and 45°C, the charger will automatically

begin charging

- the lithium-ion battery can be charged at any time

(interrupting the charging procedure does not

damage the battery)

- while charging, the charger and the battery may

become warm to touch; this is normal and does not

indicate a problem

- do not charge at temperatures below 0°C and over

45°C; this will seriously damage the battery as well

as the charger

- when the lithium-ion battery is empty, the tool is

switched off automatically

! do not continue to press the on/off switch after

the tool is switched off automatically; battery may

be damaged

• Changing direction of rotation 0

- indicator E shows the selected direction of rotation

- when not properly set in left/right position, switch

A 2 cannot be activated

! change direction of rotation only when tool is at a

complete standstill

• Changing bits !

- insert the bit as deep as possible in the chuck

! do not use bits with a damaged shank

! only use sharp bits

• Torque control (VariTorque) @

- output torque will increase as clutch ring G is rotated

from 1 to 7; position H will lock up the clutch to

permit drilling or driving heavy duty work

- when turning in a screw, first try VariTorque position 1

and increase until the desired depth has been

reached

• Mechanical gear selection #

- set selector J to desired speed

! actuate the gear selector while tool is running

slowly

HIGH POWER

- high torque

- for screwdriving and drilling large diameters

- for tapping thread

HIGH SPEED

- lower torque

- for drilling small diameters

• Low battery level indicator $

When battery level is low, indicator K lights on

• Mounting charger on the wall %

• Holding and guiding the tool

! while working, always hold the tool at the grey-

coloured grip area(s) ^

- keep ventilation slots L 2 uncovered

- do not apply too much pressure on the tool; let the

tool do the work for you

APPLICATION ADVICE

• When drilling ferrous metals

- pre-drill a smaller hole, when a large hole is required

- lubricate drill bit occasionally with oil

• When turning in a screw at/near the cross cut end or an

edge of wood, pre-drill a hole in order to avoid cracking

of the wood

• For an optimal use of the tool a steady pressure on the

screw is required, especially while removing

• When screwdriving in hard wood one should pre-drill a

hole