17_8.Cleaning Aluminium Parts; 17_9.Parts Inspection; Dismantling The Unit - Specialised Technician - Arneg Wels-Wels R290 Manuel D'installation Et D'utilisation

17_8.Cleaning aluminium parts

DO NOT use acid or alkaline detergents (e.g. bleach) which could corrode the
surface
DO NOT use rough or abrasive materials or metallic scrapers that could
scratch the glass surfaces
DO NOT use steam cleaning equipment
DO NOT use dirty cloths
Use a soft cloth with a neutral detergent or soap and lukewarm water (max
30°C).
Immediately remove all traces of water or detergent using a dry cloth in order
to avoid the formation of marks.
All cleaning operations, including disinfection, rinsing and drying must be
performed carefully, removing all traces of water and detergent so as to avoid
the proliferation of bacteria that is harmful to health. Parts left to dry with
residual detergent of disinfectant may be damaged.
Remove any elements such as sponges, clothes, detergent residue, or water
from the floor that could cause slipping and accidental falls.

17_9.Parts inspection

Once cleaning, disinfection, rinsing, and drying operations have been completed,
carefully check that all the parts are perfectly clean and dry and have not been
damaged or excessively worn. If necessary, replace them.
Attach the elements once perfectly dry and restore the electrical power supply. Once
internal operating temperature has been reached, the unit can be loaded with the
products to be displayed.

18.Dismantling the unit - specialised technician -

The unit must be disposed of in accordance with your country's waste management
legislation and in respect of our environment. This product is considered by current
legislation as hazardous waste. It must therefore be collected separately and cannot
be treated as household waste nor sent to a landfill. Before disposing of the unit, the
refrigerant must be collected and the lubricant oil removed. This product consists of
75% recyclable materials.
Materials used in construction:
- Stainless steel 18/10 (AISI 304):various finishing
- Section bars and pipes in iron: lower frame
- Copper, Aluminium:
- Galvanised sheet:
- Foam polyurethane (CO
- PVC:
- Wood:
05060074 02 19/08/2014
refrigerating circuit, electric system, various finishing
motor base
): thermal insulation
2
bumper profiles, discharge pipe for defrost water
foamed tray side frames
Wels-WelsR290
English
33