A Propos De La Déclaration De Conformité - Epson EMP-8300 Guide De Mise En Route

A propos de la déclaration de conformité
MODEL: TMW1008
FCC ID: NUSTMW1008
This device complies with Part 15 of the FCC Rules. Operation is subject to
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation.
1. Feature
Completely Covered Assembly is Designed to fully packaged in a PCMCIA Type II
extended cover set.
This equipment has been tested and found to comply with the limits for a Class B
Personal Computer and Peripheral, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment dose cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment has been tested to comply with the limits for a Class B personal
computer and peripheral, pursuant to Subpart B of Part 15 of FCC Rules. Only
peripherals (computer input/output devices, terminals, printers, etc.) certified (DoC)
or verified to comply with Class B limits may be attached to this equipment.
Operation with non-certified (DoC) or non-verified personal computer and/or
peripherals is likely to result in Interference to radio and TV reception. The
connection of a unshielded equipment interface cable to this Equipment will
invalidate the FCC Certification of this device and may cause interference levels
which Exceed the limits established by FCC for equipment.
You are cautioned that changes or modifications not expressly approved by the
party responsible for compliance could void your authority to operate the
equipment.
95