Safety Precautions - Before You Begin - hestan KRT304-NG Manuel D'utilisation Et D'entretien

SAFETY PRECAUTIONS - BEFORE YOU BEGIN

(CONTINUED)
GAS SUPPLY
A gas shut-off valve must be located in an easily accessible location for servicing of the rangetop.
Make sure all users of the rangetop know where this shut-off is located, and how to shut off the gas.
EN
The type of gas should be verified prior to installation and operation of this appliance. It is the
responsibility of the user to have the appliance connected
by a licensed plumber in accordance with all local codes,
SHUTOFF VALVE
or in the absence of local codes, in accordance with the
IN OPEN POSITION
National Fuel Gas Code.
When connecting to LP gas, verify the tank is equipped
GAS
with its own high pressure regulator. The pressure of the
SUPPLY
gas supplied to the appliance must be 11-14 inch WC [2.74-
3.48 kPa]. Consult the Installation Manual for details on gas
type, gas pressure, connection and leak testing instructions,
etc.
Read the GAS CONNECTIONS section of the Installation
TO
Manual for complete details.
APPLIANCE
CONVERSION KITS
In the event your Hestan appliance needs to be converted from NG to LP, or vice-versa, you will
need to contact Hestan Customer Service to arrange a service call. This conversion should only be
performed by a qualified technician.
HIGH ALTITUDE KITS
If you live in a high altitude area, 2,000 ft. [610 m] or more above sea level, your appliance may
require different orifices for proper combustion and performance. You will need to contact Hestan
Customer Service to arrange a service call. High Altitude kits must be installed by a qualified
technician. Please have your model and serial number information ready when you call.
BACKGUARD
Your Hestan rangetop is supplied at the factory with an Island Trim backguard. See Table 1 in the
APPENDIX section of the Installation Manual for other backguard options available from your
Hestan dealer, or visit www.hestanhome.com. Selection of the appropriate backguard depends on
the installation location and adjacent materials, and the type of vent hood to be used. Installation
instructions are included with the backguard kit. A LOW OR TALL BACKGUARD IS REQUIRED
WHEN INSTALLING THE RANGETOP AGAINST A COMBUSTIBLE SURFACE - THE ISLAND TRIM
IS NOT SUITABLE.
CAUTION
The top of the backguard serves as an exhaust vent to remove heat from under the rangetop. DO
NOT BLOCK or obstruct the top of the backguard. DO NOT touch the top of the backguard during
appliance operation as it may get hot. Allow sufficient time to cool before touching or cleaning this
area. DO NOT position plastic or other heat-sensitive items nearby which could melt or burn.
VENTILATION REQUIREMENTS
It is strongly recommended that this appliance be installed with a Hestan vent hood. Hestan vent
hoods have been matched up to the BTU output of the rangetop. Due to the high heat output of this
rangetop, it is very important that the hood and ductwork installation meets local building codes and
is installed by a qualified technician.
Do not use a down-draft style ventilation system.
Do not mount a microwave oven/ventilator combination above the rangetop. These types of units
do not have sufficient airflow to remove the high heat output of this rangetop and were not tested
with this type of appliance.
Consult the Installation Manual for further details.
4
©2019 Hestan Commercial Corporation