Sealed Burners; First Time Operation - hestan KRT304-NG Manuel D'utilisation Et D'entretien

GETTING STARTED WITH YOUR APPLIANCE

SEALED BURNERS

Ensure the sealed burner heads are properly installed and seated on the burner base as shown below.
There are notches on the burner base and cross ring to help with alignment. The outer burner head
EN
features a long slot on the top of the head which aligns with the spark igniter. Assembly of the
single-flow burner head is similar.
OUTER
BURNER
HEAD
BEAUTY
RING

FIRST TIME OPERATION

When using your rangetop for the first time, any manufacturing oils and residues on the grates will
be burned off. This may produce a little smoke and some odor. This is normal and is typical of any
new appliance when first used. If the smell is strong, remove persons and animals from the kitchen
during this period. Open any windows to further vent the odor from the room.
Ensure there are no packaging materials remaining. Remove any labels or plastic film from the
outside of the appliance. Install all the cooking grates and griddle plate (if equipped).
BURNER HEADS
If the burner head is not properly positioned, one or more of the following issues may occur:
• Flames too high
• Flames shoot out of the burners
• Burners do not ignite
• Flames are uneven
• Burner emits a gas odor
BURN HAZARD - To prevent burns, do not touch the burner heads or cooking grates when hot.
Allow to cool completely. To prevent flare-ups, do not use the burner without all the burner heads in
place and properly positioned. Do not use aluminum foil to line the surface burners. Doing so may
result in a risk of electric shock, or fire.
12
©2019 Hestan Commercial Corporation
INNER
BURNER
HEAD
DUAL FLOW BURNER
CROSS
RING
BURNER
BASE
SINGLE FLOW BURNER
(CONTINUED)
BURNER
RING
BURNER
HEAD
BURNER
BASE
IGNITER