Silverline 942944 Mode D'emploi page 8

GB
Troubleshooting
Problem
No function when Throttle Trigger
(11) is operated. Oscillating
Spindle (21) rotates freely
Drive Pulley (12) performance
is restricted, yet air flows freely
from the tool
Seized Drive Pulley (12)
Sander will not turn off when
Throttle Trigger (11) is released
8
Possible Cause
Air supply issue
Defective Throttle Trigger or throttle components
Internal vane seized
Broken internal vane
Defective internal Throttle Trigger components
Solution
Check all connections between compressor and tool, and ensure the
operating pressure is set correctly
In the event the internal throttle mechanism becomes jammed. Check for
dirt within the Air Inlet (6) and remove. Pour a small amount of air tool
oil (included) into the Air Inlet, reconnect the air supply and operate the
Throttle Trigger in small bursts. If the tool still ceases to function, return
to an authorised Silverline service centre
Disconnect the air supply. Pour a small amount of air tool oil (included)
into the Air Inlet (9), reconnect the air supply and operate the Throttle
Trigger in small bursts. Periodically tap the Drive Pulley using a rubber
mallet (not included). If the tool still ceases to function, return to an
authorised Silverline service centre
Return to an authorised Silverline service centre
Return to an authorised Silverline service centre