Menu Options - Promax OP-009-PS Manuel D'utilisation

3.2.2

Menu Options

After installing and connecting this module, user can use the analyser for
measurement of optical signals as if it were RF signals. Steps to measure a signal are
as follows:
1.- On the analyser, select the frequency band, terrestrial (for optical links) or
satellite (for optical LNB), by pressing the
two bands.
2.- Access the menu for measurement of optical fibres by pressing the EXTERNAL
UNITS POWER SUPPLY
3.- Select the OPTICAL LNB option and switch it to ON.
4.- Next the menu of the conversion module appears. Depending on whether is
terrestrial or satellite signal, the menu changes (see figure).
Figure 9.- Terrestrial Optical signal.
Figure 10.- Satellite Optical signal.
Page 12
User's Manual OP-009-PS
[14] key to switch between these
[11] key.
09-2012