Promax OP-009-PS Manuel D'utilisation page 29

User's Manual OP-009-PS
3.- Connect the TV EXPLORER
that is going to be measured, such as for example in a UAP (User Access
Point).
4.- Using the TV EXPLORER HD, check measurements on the FIBRE OPTIC
TEST screen.
5.- Press the UTILITIES key
DATALOGGER and press the rotary selector.
6.- Select the option NEW DATALOGGER and press the rotary selector.
7.- The screen to capture data appears. Select the START button and press the
rotary selector.
8.- The TV EXPLORER
access point measures for all three wavelengths.
9.- At the end of the point measurement select SAVE and press the rotary
selector.
10.- When measuring the next access point at the same installation, select the
same datalogger file to continue with the next measuring point. Repeat for
each one of the access points (see figure below).
09-2012
HD to a receiving node of the optical network
[22], then select the option RUN
HD starts to measure and stores in memory the user's
Figure 7.-
Page 9