Dismantling And Disposal - CAME ZLJ14 Manuel D'installation

DIAGRAM OF THE SLOW-DOWN AND FINAL APPROACH POINTS AND FOR THE ENCODER DEVICE
 The run area and slow down and approach points are tested according to the parameters set forth by Technical Standards EN 12455 and
EN 12453 for compliance with the impact forces generated by the running leaves.
B
D
I
H
A = Normal speed
B* = Slowed-down speed
C = Encoder intervention zone with movement inversion
D = Encoder intervention zone with movement stopped
= Opening slow-down starting point [OP. SlwDwn%]
E
= Closing slow-down starting point [CL. SlwDwn%]
F
G** = Closing soft-stop starting point [Acc. CL%]
= Opening soft-stop starting point [Acc. OP%]
H
I = Final strike-point
* Minimum 600 mm from the strike plate.
** Set the fi nal approach percentage for the function [Acc. CL%] and [Acc. OP%] from the [ENCODER] menu so as to obtain a distance of
between 1 and 50 mm maximum from the fi nal strike plate point.

DISMANTLING AND DISPOSAL

Always make sure you comply with local laws before dismantling and disposing of the product. The packaging materials (cardboard, plastic, and
so on) should be disposed of as solid urban waste, and simply separated from other waste for recycling.
Whereas other components (control boards, batteries, transmitters, and so on) may contain hazardous pollutants. These must therefore be
disposed of by authorized, certified professional services.
DO NOT DISPOSE OF IN NATURE!
I
D
B
A
F
C
E
G