JRG Sanipex MT Notice D'utilisation Et D'entretien page 168

E
4.5 Installation procedure JRG Sanipex MT d16-d63
Warning:
Incorrectly formed pipe flares
Incorrectly formed pipe flares must not be flared again!!

168
Correct clamping joint
Checking the
expansion process:
The O-ring on the
fitting must be fully
covered by the flanged
pipe.
Guide flanged JRG
Sanipex MT pipe onto
the JRG Sanipex MT
fitting. Tighten the cap
nut by hand.
Wrong clamping joint

Tighten cap nut with
the ratchet torque
wrench (JRG Code
4832) until an audible
"click". To hold steady,
apply counter pressure
using the counter key
(JRG Code 4834) on the
JRG Sanipex MT fitting.