Application; General - flamco VHW 260 Installation Et Mode D'emploi

1. APPLICATION

Please read the installation instructions before installing the appliance!
!
Please read the operating instructions before commissioning the appliance!
Please observe the safety instructions in the operating instructions!
The installation location must meet the requirements for sufficient ventilation!
Installation must only be carried out by an authorized contractor!
1.1

GENERAL

The appliance may only be used for DHW (Domestic Hot Water) heating. Using the equipment for any other purpose
will be considered incorrect use. Flamco accepts no liability for any damage resulting from such use.
The appliance is not suitable for commercial or industrial applications. It is approved for household use only.
The VHW 260 is a heat pump for DHW heating with the following specifications:
• (H) CFC-free polyurethane hard foam isolated (70 mm) vessel of stainless steel (1.4521).
• Indirect heating of DHW.
• Refrigerant R134a.
• Temperature DHW adjustable between 30 °C to 70 °C.
•
Automatically switch-off heat pump when air temperature outside of range -10 °C to 35 °C.
• Easy serviceable.
• No Fluor gases certification needed for changing the complete heat pump assembly.
3