Date - Setting The Temperature Unit, Date, Time And Day Of The Week; Prog - Programming Of The Operating Times - flamco VHW 260 Installation Et Mode D'emploi

4.8.1 DATE - SETTING THE TEMPERATURE UNIT, DATE, TIME AND DAY OF THE WEEK

1. Select the temperature unit using the "+" or "-" button.
2. Confirm by pressing "OK".
3. Set the day of the week using the "+" or "-" button.
4. Confirm by pressing "OK". The hour flashes on the display.
5. Set the hour using the "+" or "-" button.
6. Confirm by pressing "OK". The minutes flash on the display.
7. Set the minutes using the "+" or "-" button.
8. Confirm by pressing "OK".
9. The process of setting the clock is complete.
Monday is set as the first day of the week by default. Depending on individual
requirements, the user can choose to set a different day as the first day of the
week.

4.8.2 PROG - PROGRAMMING OF THE OPERATING TIMES

In the "Prog" submenu, you can set the operation period for the heat pump.
The following menus can be called up in the "Prog" submenu:
•
"P1" operating time (days 1 to 5)
• "P1" operating time (days 6 and 7)
• "P2" operating time (days 1 to 5)
• "P2" operating time (days 6 and 7)
• "P3" operating time (days 1 to 5)
• "P3" operating time (days 6 and 7)
"P1" operating time
The heat pump only goes into operation during the operating times
set at the factory. These cannot be changed: Days 1 - 5: [00:00 •
06:00] and [16:00 • 19:00] Days 6 - 7: [02:00 • 08:00]
1 2 3 4 5 6 7
am auto
pm
man
prog
kWh
0 6 12 18 24
1 2 3 4 5 6 7
am auto
pm
man
prog
kWh
0 6 12 18 24
1 2 3 4 5 6 7
am auto
pm
man
kWh prog
0 6 12 18 24
1 2 3 4 5 6 7
am auto
pm
man
prog
kWh
0 6 12 18 24
21