Sinmag Europe SM3-30 Mode D'emploi page 3

1. Installation
Use the attached paper with anchor bolt position drawing to prepare
the 4 anchor bolts on the ground. When the 4 anchor bolts are ready,
put the machine on the position that the 4 anchor bolts go through
the holes of the frame. Tighten the nuts of the anchor bolts to fix the
machine in position.
Take out the moulding plate Part N°42, fill with the attached lubrication
oil for the moulding mechanism.
The moulding plate must be put back correctly. The slits in the base
footing of the moulding plate have to fit upon the upper sliding faces
of the side and the pin of the drive shaft has to fit into the ball bearing
of the moulding plate.
The best way to carry this out, is to attach the moulding plate at the
side and then lift one side in order to check whether all parts have
been positioned correcly.
Before assembling the moulding
plate, the slide has to be fitted in
accordance with the two red marks
which are shown on the small cover
sheet. Then the moulding plate can
be inserted vertically from above in
order that the driving pin and the
parallel guide of the slide fit in the
corresponding holes and slits. After assembling the moulding plate,
check correct position by operating the moulding lever.
Connect the electric supply according to the voltage shown on the
name plate. When the power is connected, the machine is now ready
for operation.
SINMAG EUROPE BVBA
ENG
3