Emergency Mode; Entering Or Exiting Emergency Mode; Sending An Emergency Alarm (Tmo Only) - Motorola MTH800 Guide D'utilisation

Emergency Mode

You can send and receive Emergency Group Calls in Trunked
Mode or in Direct Mode. If your terminal is configured to operate
through a gateway, Emergency calls can be placed through the
gateway.
You can initiate an Emergency Group Call to and receive it from the
selected group (TMO and DMO).
Your Service Provider will configure the Emergency Alarm and Hot
Microphone features.
Emergency calls will be allocated emergency priority in the system.

Entering or Exiting Emergency Mode

To enter Emergency Mode, press and hold the Emergency button
at the top of the MTH800.
The required time you need to press the Emergency button is set to default
to 0.5 seconds. The time can be configured by your Service Provider.
To exit Emergency Mode, press and hold Exit. Your terminal will
switch to the Home display.

Sending an Emergency Alarm (TMO Only)

Your MTH800 will automatically send an Emergency Alarm when in
Emergency Mode. This is sent:
• automatically, upon entering Emergency Mode
• if you press the Emergency button again while the MTH800 is in
Emergency Mode.
After sending the alarm, the display will show one of the following
delivery reports:
• Alarm Sent
• Alarm Failed
In both cases the display returns within a few seconds to the main
screen of the Emergency Mode.
The Emergency Alarm is a special status message sent to the dispatcher
monitoring the selected group. This can be used in dispatch systems to
highlight emergency calls.
32