Setup / Installation; Assembly / Disassembly - Sera MU- 300 E 187.2 Mode D'emploi

Electric agitator
MU-037300 E 187.2
MU-055450 E 114.2 / MU-075550 E 094.2
Operating instructions

6. Setup / Installation

The electric agitator is only approved for installation in dry areas in a non-aggressive atmosphere at temperatures
■
between +2° and +40°C and an air humidity of up to approx. 90%.
No exposure to direct sunlight.
■
For the dimensions of the fixing holes of the protective flange, see chapter "Dimensions".
■
Check that the fixing screws are tightly fitted and retighten the nut, if necessary
■
(tightening torques see chapter "Assembly / Disassembly").
Install the electric agitator at the optimum possible operating height.
■
Maximum installation height is 2000m (reduction in performance above 1000m above sea level).
■
Minimun immersion depth (½ Agitator diameter)
■
CAUTION!

7. Assembly / Disassembly

Prior to work, turn off the power and protect the system from being turned on again!
■
DANGER!
Prior to work, ensure that there is sufficient space to perform the installation.
■
Be careful when handling sharp-edged components.
■
Make sure the work station is tidy and clean! Loose parts or parts and tools lying around may cause accidents.
■
Secure components so that they can not fall down or topple over.
■
CAUTION!
TA 504 Vers. 3 en 11/2021
The Electric agitators are not suitable for pass-through operation.
In case of contact with live components there is danger to life.
Switched on electrical components may cause uncontrolled movements
and lead to serious injuries!
An improper installation and initial start-up may lead to serious damage to per-
sons or property!
Subject to technical modifications! www.sera-web.com
47