Low Flame Adjustment - Fulgor Milano Sofia 30 Instructions D'installation

Low Flame Adjustment

DANGER
Lighting gas burners with a match is dangerous.
You should match light the burners only in an emergency.
Light a match and hold the flame near the burner you
want to light. Wooden matches work best.
Push in and turn the control knob slowly.
Be sure you are turning the correct knob for the burner
you are lighting.
NOTE: If the burner does not light within five seconds,
turn the knob off and wait one minute before trying
again.
CAUTION
If you attempt to measure the inner cone of the flame,
please use caution.
Burns could result.
This appliance is shipped from the factory with low and
medium flame settings adjusted.
If further adjustment is necessary, proceed as follows:
6 - Conversion for LP or NG Gas
Adjustment for Burners with one or two
flame rings:
1. Light burner and set control knob for low flame.
2. Remove control knob from valve stem.
3. Remove knob seat from control panel.
4. Insert a slender, thin-blade screwdriver into the recess
5. Turn adjusting screw to set flame size:
6. Replace control knob when adjustment is completed.
ADJUSTMENT FOR COOKTOP BURNERS
behind the control knob (A or B) and engage blade with
slot in adjusting screw.
• clockwise to reduce
• counterclockwise to increase
EN
A SIMMER
B MAIN FLAME
23