Fulgor Milano Sofia 30 Instructions D'installation page 15

2" (5)
If the surface of the entire back wall above the range and below the hood is not composed of a non-combustible
material then the 9" accessory back guard must be used.
*Consult local code for exact location requirements.
OPENING
WIDTH
Rangetop 48" 48" (122.2) 42 3/8 (107.7)
Note: Clearances from non-combustible materials are
not part of the ANSI Z21.1 scope and not certied.
Clearances to non-combustible materials must
conform with local codes or, in the absence of
local codes, with the National Fuel Gas Code,
ANSI Z223.1/NFPA 54.
Minimum clearances:
Above cooking surface (above 36" [91.4 cm])
• Sides - 6" (15.2 cm)
• Within 6" (15.2 cm) side clearance, wall cabinets
no deeper than 13" (33.0 cm) must be minimum 18"
(45.7 cm) above cooking surface
• Wall cabinets directly above product must be a
minimum of 48" (122 cm) above cooking surface, no
deeper than 13" (33.0 cm).
• Rear - 0" with 9 " backguard; 0" with non-combustible
rear wall.
Below cooking surface (36" [91.4 cm] and below)
• Install with zero clearance
combustible construction below the cooking surface
and the back and sides of the appliance.
2 - Product Dimensions and Cutout Requirements
INSTALLATION ON OPEN FRAME 48''
EMPTY SPACE
48 1/8" (122.2)
CUTOUT REQUIREMENTS 48"
A B
between adjacent
2" (5)
2" (5)
A
ADDITIONAL CLEARANCES:
For island installation, maintain 2-½ in. minimum from
cutout to back edge of countertop and 3 in. minimum
from cutout to side edges of countertop (see top view).
For installation in a stepped island, 12" (30.5 cm)
minimum clearance is required from the back or sides of
the rangetop to a combustible riser.
The island installation is not part of the ANSI Z21.1
scope and not certified.
FLUSH ISLAND INSTALLATION 48''
min 3" (7.6)
2" (5)
BACK
min 3" (7.6)
EN
11