Preparation - Beko TS1 90020 Manuel D'utilisation

4

Preparation

• Your refrigerator should be installed at
least 30 cm away from heat sources such
as hobs, ovens, central heater and stoves
and at least 5 cm away from electrical
ovens and should not be located under
direct sunlight.
• The ambient temperature of the room
where you install your refrigerator
should at least be 10°C. Operating your
refrigerator under cooler conditions is
not recommended with regard to its
efficiency.
• Please make sure that the interior of your
refrigerator is cleaned thoroughly.
• If two refrigerators are to be installed side
by side, there should be at least 2 cm
distance between them.
• When you operate your refrigerator for
the first time, please observe the following
instructions during the initial six hours.
• The door should not be opened
frequently.
• It must be operated empty without any
food in it.
• Do not unplug your refrigerator. If a power
failure occurs out of your control, please
see the warnings in the "Recommended
solutions for the problems" section.
• Original packaging and foam materials
should be kept for future transportations
or moving.
• The baskets/drawers that are provided
with the chill compartment must always
be in use for low energy consumption
and for better storage conditions.
• Food contact with the temperature
sensor in the freezer compartment may
increase energy consumption of the
appliance. Thus any contact with the
sensor(s) must be avoided.
• In some models, the instrument panel
automatically turns off 5 minutes after
the door has closed. It will be reactivated
when the door has opened or pressed on
any key.
• Due to temperature change as a result of
opening/closing the product door during
operation, condensation on the door/
body shelves and the glass containers is
normal
15
EN