Double Oven Installation - Whirlpool WOS52ES4M Manuel D'installation

4. Securely fasten oven to cabinet using the 4 x 25 mm self-
tapping screws provided (1 on each side). Insert the screws
through holes in mounting rails. Do not overtighten screws.
A
A. 4 x 25 mm self-tapping screws
5. Install the oven racks.
6. Replace oven door by inserting both hanger arms into the
door.
7. Open the oven door. You should hear a "click" as the door is
set into place.
8. Move the hinge levers back to the locked position.
9. Check that the door is free to open and close. If it is not,
repeat the oven door removal process and installation
procedures. See "Remove Oven Door" section.
10. Reconnect power.
11. On some models, the display panel will light briefly, and "PF"
should appear in the display.
12. If display panel does not light, please reference the
"Assistance or Service" section of the Use and Care Guide
or contact the dealer from whom you purchased your oven.
12

Double Oven Installation

Trim Kit description:
D
A. Left bracket
B. Right bracket
NOTES:
1. These instructions refer to "Upper Oven" and "Lower Oven".
The Lower Oven is identified by a label on top of the product.
2. Connection will be made for both units to existing bare wire
(Red to Red, Black to Black, etc) simultaneously.
3. The junction box is not a supplied part. Standard 4" x 4" box
can be used.
4. The products is equipped with an electrical conduit that
allows to place the Junction Box in the area measured
1304 mm from the bottom of the cabinet to top of the
electrical box, across the entire width of the cabinet
5. Electrician may be required to locate junction box out of the
defined installation area.
A
A. Cabinet Opening
B
A
C
C. Front aesthetic panel
D. Front flange of the
bracket
1304 mm
85 mm