Hot Water; Programmable Functions - Breville the Dual Boiler BES920XL Manuel D'instructions

oPERAtInG yoUR BREvILLE PRodUCt
MAnUAL BUtton
The MANUAL button allows you to control
the espresso duration/volume to suit your
preference. Press MANUAL button once to
start the espresso extraction.
The extraction will start using the low
pressure pre-infusion. Press MANUAL
button again to stop extraction.
tIP
To manually control the low pressure
pre-infusion duration, press and
hold the MANUAL button. When the
required pre-infusion duration is met,
release button to begin full pump
pressure. Press MANUAL button
again to stop extraction.
16
StEAM
For instant steam, move STEAM LEVER
to OPEN position. The STEAM LED will
illuminate.
To turn steam off, move STEAM LEVER to
CLOSED position. The machine will return
to STANDBY mode.
CAUTION: BURN HAZARD
Pressurized steam can still be released,
even after machine has been switched off.
Children must always be supervised.
PAge heAder..... oPERAtInG yoUR BREvILLE PRodUCt

hot WAtER

For instant hot water, rotate the HOT
WATER dial to OPEN position. The HOT
WATER LED will illuminate.
To turn hot water off, rotate the
HOT WATER dial to CLOSED position.
The machine will return to STANDBY mode.
notE
You cannot run hot water and extract
espresso at the same time.
notE
Hot water will cease to dispense after
approx. 30 seconds. Depending on
the size of your cup, you may need to
close, then re-open the HOT WATER
dial. See 'HOT WATER LED flashing',
page 23.

PRoGRAMMABLE fUnCtIonS

To enter program mode, press the MENU
button. Continue to press MENU button
until the desired function is flashing on
the LCD.
Program mode allows you to program:
• Shot Volume
• Shot Temperature
• Auto Start
• Clean Cycle
• Set Clock
To exit program mode, press EXIT button.
notE
The MENU button is disabled during
an extraction or when dispensing
hot water.
17