Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DAV
6.4 Setting up the DAV
1
1
Gas nozzle
Fig. 6
DAV wire cutting device
X
1 Briefly trigger the current-less wire feeder.
2 Move the torch with the free wire end and the dimension X to the cutting
area of the wire cutter (2).
The wire must lie against the fixed jaw and the gas nozzle (1) must be directly
above the cutter.
Programme the way points and commands as described in the flow chart.
Fig. 7 Flow chart on page EN-18
3 Set the Cut robot signal.
4 After a brief wait, reset the switching state.
5 Move the torch upwards out of the wire cutter (2) DAV.
NOTE
• Worn-out cutting edges may cause malfunctions. A cost- and time-saving
remedy is to correct the start-up position by a few millimetres. Only when
the entire cutting width of the cutter has been worn out, will a
replacement be required.
9.1.1 Changing the cutter on page EN-20
2
Wire cutter
6 Putting into operation
2
EN - 17
Publicité
Table des Matières
