Bartscher A200.052 Mode D'emploi page 26

CAUTION!
It is important that there is always drinkable liquid in the container before
engaging the device. You must not pour undrinkable liquids such as acids, bases
or leys, oils, nitrates etc. in the mulled wine pot/preserving pot.
•
Pour the desired drinkable liquid in the mulled wine pot/preserving pot. Minimum
filling quantity of 5 litres.
WARNING!
Never use the device when it is not filled with liquid!
•
Put the plug in the power socket (the red control light will go on).
WARNING! Hazard via electrical current!
During operation it must be ensured that no liquids can spill over as this can
cause short-circuits in the electronic control.
Personal injury can be the result.
Pay attention to the labels inside the container!
•
Before starting the device, put the glass cover so as to avoid temperature loss in
the container.
WARNING! Danger of burn!
During taking the lid off there is a danger of burn by the escaping steam and
condensate! Be particularly careful while doing this!
•
With the use of the temperature control it is possible to adjust the temperature
gradually from approx. 30
•
Set the temperature control at the desired temperature by turning it clockwise (the
green control light of heating will go on). When the desired temperature is reached,
the control light goes off.
NOTE!
The heat is created via a heating coil in the bottom part of the mulled wine
pot/preserving pot. The electric temperature control with the temperature sensor
are placed here as well. The adjustment of temperature is done via the thermostat
switch.
- 26 -
° °
C - 100 C.